indicator_response_state

This data element contains the current state of an indicator that is being used to control traffic on the roads (surface streets) and highways in the geographic area served by the TMC. It is used to check that the indicator is performing as requested and may form the basis for a fault report if it is not. The data flow identifies the indicator state. Examples of typical states are correct operation, not responding, stuck on phase, and phase will not respond.

Sub Data Flows

• Primitive Element

Parent Data Flows

• f_other_rw_fc_status_to_fc
• f_other_rw_ic_status_to_ic
• fors-traffic_meter_data
• indicator_input_data_from_signals
• indicator_input_data_from_traffic_meters
• indicator_input_storage_data_for_highways
• indicator_input_storage_data_for_roads
• indicator_response_data_for_highways
• indicator_response_data_for_roads
• intersection_state_data
• other_indicator_input_data_from_highways
• t_other_rw_fc_status_to_fc
• t_other_rw_ic_status_to_ic
• tors-traffic_metering_data

Associated PSpecs/Terminators

• None